11/8/2022 0 Comments Dragonframe 3.0 serial number
var/folders/2d/0b58mqnx2ybfqvbnj50b57yr0000gn/T/arduino_modified_sketch_626896/DFMoco.pde: In function 'void setupMotorMove(int, int32_t)':ĭFMoco:1005:50: error: 'calculatePointToPoint' was not declared in this scopeĬalculatePointToPoint(motorIndex, destination) var/folders/2d/0b58mqnx2ybfqvbnj50b57yr0000gn/T/arduino_modified_sketch_626896/DFMoco.pde: In function 'void updateMotorVelocities()':ĭFMoco:922:14: error: 'hardStop' was not declared in this scope var/folders/2d/0b58mqnx2ybfqvbnj50b57yr0000gn/T/arduino_modified_sketch_626896/DFMoco.pde: In function 'void loop()':ĭFMoco:873:29: error: 'updateMotorVelocities' was not declared in this scopeĭFMoco:875:26: error: 'processSerialCommand' was not declared in this scopeĭFMoco:887:23: error: 'nextMessage' was not declared in this scopeĭFMoco:901:28: error: 'sendMessage' was not declared in this scope var/folders/2d/0b58mqnx2ybfqvbnj50b57yr0000gn/T/arduino_modified_sketch_626896/DFMoco.pde: In function 'void setup()':ĭFMoco:573:31: error: 'setPulsesPerSecond' was not declared in this scopeĭFMoco:647:20: error: 'sendMessage' was not declared in this scope I know enough to be dangerous but not enough to troubleshoot specifics like this. I'm hoping someone might have some idea what might be wrong here. Other than the board selection I've made in Arduino though I don't think this is hardware related.I'm just trying to verify the sketch and getting the error below. I'm getting a compile error that I can't find any reference to so assume I must be having a unique issue? I'm using an Arduino Uno with CNC shield 3. I actually downloaded the sketch from post #10 and made the amendments as noted in post #37, overwriting the sketch that was supplied with DragonFrame (I kept a backup). I've been through this entire thread and with the exception of the salesarea link from early on in the thread being dead am assuming I have everything right. #Dragonframe 3.0 serial number how to#
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |